Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|

Custom Search

Pool screen frame support attach to gutter.

Pool screen frame support attach to gutter.

New postby RICHARD TAN on Mon Feb 02, 2009 6:29 pm

Codeman,

Pool screen frame support attach to gutter, gutter attach to the fascia board or roof sheeting, I have found many of this type of installation failed in few years, is there a code for installation of pool frame support. I know there is some gutter that is made or rated to support the pool frame but found out in several they also failed.
RICHARD TAN
 
Posts: 60
Joined: Wed Jan 14, 2009 9:43 am

Re: Pool screen frame support attach to gutter.

New postby Jerry Peck - Codeman on Wed Feb 04, 2009 11:02 am

Hi Richard,

I've been looking for a more precise and applicable reference to give you, but it turns out to be one of those "The building code is a minimum standard and does not, cannot, address basic construction knowledge or common sense." aspect.

From the 2004 Florida Building Code, Residential, w/2006 Revisions:
- SECTION R301
- - DESIGN CRITERIA
- - - R301.1.3 Engineered design.
- - - - When a building of otherwise conventional construction contains structural elements exceeding the limits of Section R301 or otherwise, not conforming to this code, these elements shall be designed in accordance with accepted engineering practice. The extent of such design need only demonstrate compliance of nonconventional elements with other applicable provisions and shall be compatible with the performance of the conventional framed system. Engineered design in accordance with the Florida Building Code, Building is permitted for all buildings and structures, and parts thereof, included in the scope of this code.

Pool screen enclosure members are typically attached to what is referred to as a 'structural gutter', and that structural gutter is attached to the structure as required by the engineering.

If the fascia is a 2x fascia, then most likely the gutter could be attached to the fascia. However, if the fascia is a 1x fascia, then the gutter would more likely have to be attached through the fascia to the rafter or truss tails.

It is not unusual to find fascia which is wood decayed, and that could lead to the failure of the fasteners and attachment points/brackets/etc, which could allow the screen enclosure framing to pull the gutter loose under uplift conditions (typically, under gravity load conditions, the weight of the screen enclosure frame itself will help hold the structural gutter to the structure). I have, as several occasions, found where the weight of the screen enclosure frame on the structural gutter has caused the structural gutter to sag, and upon examination I could always see the lag bolts being pulled down and out at an angle through wood decayed fascia.

The answer to your question would be that the applicable code would be the engineering.

One improvement which could be made in this process is that, while the screen enclosure is already "engineered", the installation of it is not "signed off by the engineer". If the screen enclosure designer was also required to inspect each installation, then issue an engineer's letter stating that the screen enclosure was installed in accordance with the engineering design, and sign and seal that letter, the engineer would (I would hope) make sure the screen enclosure was attached to the structure as they intended it to be.

Codeman
Jerry Peck - CodeMan
AskCodeMan.com
Construction Litigation Consultant - Retired
Construction and Code Consultant - Semi Retired
User avatar
Jerry Peck - Codeman
Site Admin
 
Posts: 1199
Joined: Fri Dec 12, 2008 12:06 pm


Return to Pools and Spas: Swimming pools, spas, hot tubs, child safety protection, entrapment protection



Who is online

Users browsing this forum: No registered users and 0 guests


cron