Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|
The following Codemen are available to answer your questions:
All Codes and Standards - Jerry Peck, Codeman


Q&A Board links
  • REGISTER

  • FAQ

  • LOGIN

  • Q&A BOARD INDEX

  • View New Questions

  • View Unanswered Questions

  • View Active Questions/Answers

  • Mark Questions as read

  • View Your Questions

  • Go To Your User Control Panel




  • Links to:
  • Construction Litigation Consultants


  • Florida Building Commission

  • Florida Building Codes Online


  • International Code Council

  • ICC Codes Free Online


  • Building Officials and Administrators of Florida




  • Product Approvals
  • Florida Product Approval

  • ICC Evaluation Reports Search

  • Miami-Dade NOA Search




  • Inspector and Contractor License Search
  • Search Florida Licenses




  • Technical links
  • Technical Information page


























































  • Contact Codeman



  • Custom Search

    Water heater hard wire

    Water heater hard wire

    New postby FredSly on Thu Dec 12, 2019 11:54 am

    In what year or code change cycle did hard wiring 240 v water heaters go into effect and do retro fit water heaters need to meet the newer code.
    FredSly
     
    Posts: 2
    Joined: Mon Jan 29, 2018 8:08 pm

    Re: Water heater hard wire

    New postby Jerry Peck - Codeman on Thu Dec 12, 2019 8:53 pm

    FredSly wrote:In what year or code change cycle did hard wiring 240 v water heaters go into effect and do retro fit water heaters need to meet the newer code.


    I kept going back in my NEC collection and ... going back further ... and further ... and further ... then I went back to my 1905 NEC, and while the wording has changed over the editions, flexible cords on water heater was never allowed (after typing in the 1905 NEC, I will go back to the original 1897 NEC (the 1897 NEC is considered as "the first National Electrical Code").
    - From the 1905 NEC: (bold is mine)
    - - 28. Flexible Cord.
    - - - a. Must have an approved insulation and covering (see No. 45).
    - - - b. Must not be used where the difference of potential between the two wires is over 300 volts.
    - - - c. Must not be used as a support for clusters.
    - - - d. Must not be used except for pendants, wiring of fixtures, portable lamps or motors, and portable heating apparatus.
    - - - - (includes several paragraphs describing work, not applicable to this, so I did not include them)
    - - - e. Must not be used in show windows.
    - - - f. Mus be protected by insulation bushings where the cord enters sockets.
    - - - g. Must be so suspended that the entire weight of the socket and lamp will be borne by by some approved device under the bushing in the socket, and above the point where the cord comes through the ceiling block or rosette, in order that the strain may be taken from the joints and binding screws.
    - - - - (includes this note: This is usually accomplished by knots in the cord inside the socket and rosette.)

    Jerry's comments:
    - a.: a cord construction requirement
    - b.: a voltage limitation
    - c.: not applicable to water heaters
    - d.: "Must not be used except for" ... water heaters are not one of the "except for" items such as: "pendants"; nor are water heaters "wiring of fixtures"; nor are water heaters "portable" (as in "portable lamps or motors" or "portable heating apparatus")
    - e.: not applicable to water heaters
    - f.: not applicable to water heaters
    - g.: not applicable to water heaters

    Thus, even in the 1905 NEC, flexible cords were not allowed to be used for water heaters.

    The 1897 NEC wording is essentially the same for requirements and limitations; however, it includes additional wording and details which were later dropped.
    Jerry Peck - CodeMan
    AskCodeMan.com

    Construction and Litigation Consultant
    Construction Litigation Consultants, LLC.
    ConstructionLitigationConsultants.com
    User avatar
    Jerry Peck - Codeman
    Site Admin
     
    Posts: 1124
    Joined: Fri Dec 12, 2008 12:06 pm

    Re: Water heater hard wire

    New postby FredSly on Wed Dec 18, 2019 7:40 am

    Thank you Jerry for your time answering my question, much appreciated. Merry Christmas to you and yours!
    FredSly
     
    Posts: 2
    Joined: Mon Jan 29, 2018 8:08 pm


    Return to Plumbing: Water heaters, fixtures, traps, hose bibbs, water pressure, supply & DWV piping



    Who is online

    Users browsing this forum: No registered users and 1 guest



    www.AskCodeMan.com