Building Code and Building Construction - Questions and Answers
Or when you want to know how construction is supposed to be done.

|
AskCodeMan.com
|

Custom Search

Lintel Sag Formula

Lintel Sag Formula

New postby pbennett1 on Sun Jun 27, 2010 11:57 am

Hey Jerry,
Is there a formula for allowable tolerance of a sagging steel lintel?
You do not have the required permissions to view the files attached to this post.
pbennett1
 
Posts: 12
Joined: Tue May 12, 2009 7:30 pm

Re: Lintel Sag Formula

New postby Jerry Peck - Codeman on Sun Jun 27, 2010 2:48 pm

The answer is: It depends.

As in "it depends" on a variety of things. Such as: the species of the lumber, the use, the live load, the dead load, if engineered (such as LVL, I-joist, etc.), and other conditions.

Typical deflection limits, for a sampling of various conditions, might be 1/180, 1/240, or 1/360.

As example, let us take 1/240 ... that means the maximum deflection is 1/240 of the span, if the span is 16 feet (presuming a 16 foot wide garage opening), then the deflection could be 16 feet X 12 inches = 192 inches / 240 = 0.8 inches, or just over 3/4" deflection under a specific set of conditions which would allow for a 1/240 deflection.

How much is allowed in your case? I do not know, however, if you take the maximum deflection allowed for almost any condition ... 1/180 ... and use that, if that is exceeded than ... more than likely ... more than likely it would be a problem. So, let's do the above example using 1/180:
- Using 1/180 with a span of 16 feet, then the deflection could be 16 feet X 12 inches = 192 inches / 180 = 1.06 inches, or just over 1" deflection under conditions which would allow for a 1/180 deflection.
- If it sags (deflects) more than 1 inch for a 16 foot span then it is highly likely that there is a problem as that would exceed the most generous deflection allowance.
Jerry Peck - CodeMan
AskCodeMan.com
Construction Litigation Consultant - Retired
Construction and Code Consultant - Semi Retired
User avatar
Jerry Peck - Codeman
Site Admin
 
Posts: 1199
Joined: Fri Dec 12, 2008 12:06 pm

Re: Lintel Sag Formula

New postby pbennett1 on Sun Jun 27, 2010 3:17 pm

Thanks for both replies.
I will be going back tomorrow to retrieve the radon canister.
I did not take any measurements, but just "eyed" it up. The gap between the mortar joint and seems uniform in size, so I really think the "sag" maybe just shrinking mortar, thus an illusion.
PB
pbennett1
 
Posts: 12
Joined: Tue May 12, 2009 7:30 pm


Return to Exterior Clading: brick veneer; stucco; siding - vinyl, wood, cementitious (such as HardiePlank), hardboard (such as Masonite siding); EIFS



Who is online

Users browsing this forum: No registered users and 11 guests


cron